JVC SP-PWSW8 사용자 설명서

다운로드
페이지 52
Connections
12
Setting up the wireless receiver unit
1
Make sure that the CHANNEL 
SELECTOR is set to the 1 position.
2
Fully extend the telescopic antenna 
upright.
• If necessary, turn the telescopic antenna until you have the 
best reception while hearing the sound of the surround 
speakers.
NOTE
• When other DVD digital cinema system or wireless device is nearby 
this system, interference or noise may result. In such a case, change 
the channel on both the center unit and the wireless receiver unit of 
this system.
Example: When the channel 4 is selected
CAUTION
• DO NOT cover the front panel of the center unit with any metallic 
object, otherwise the radio wave cannot reach the wireless receiver 
unit.
• When you connect speakers other than the supplied ones, use 
speakers of the same speaker impedance (SPEAKER IMPEDANCE) 
indicated near the speaker terminals on the rear of the powered 
subwoofer.
• DO NOT connect more than one speaker to one speaker terminal.
• When installing the satellite speakers on the wall;
Be sure to have them installed on the wall by a qualified personnel. 
DO NOT install the satellite speakers on the wall by yourself to 
avoid unexpected damage from their falling off the wall due to 
incorrect installation or weakness in wall structure.
Care must be taken in selecting a location for speaker installation 
on a wall. Injury to personnel or damage to equipment may result 
if the speakers installed interfere with daily activities.
CHANNEL  SELECTOR
Wireless receiver unit
CHANNEL  SELECTOR
WR L S
C H :
4
Wireless receiver unit
Center unit (See “WRLS CH” in “Sound and other settings” 
(
TH-SW9SW8[B]-04Start.fm  Page 12  Thursday, April 1, 2004  11:50 AM