Shark MV2010WM 사용자 설명서
4
TOLL FREE:
1-800-798-7398
5
www.sharkclean.com
English
3
Place your foot lightly on the top
of the cleaning unit base. Tilt the
cleaning unit back. Vacuum your
floors
cleaning unit back. Vacuum your
floors
IMPORTANT: Vacuum all surfaces
first and then steam-clean to protect
the life and performance of your
product. Avoid vacuuming after
steam mopping.
first and then steam-clean to protect
the life and performance of your
product. Avoid vacuuming after
steam mopping.
NOTE: If you vacuum and then
steam-clean one room before
moving on to the next, you will
have to wait 10 minutes for the
condensation to clear before
vacuuming again.
steam-clean one room before
moving on to the next, you will
have to wait 10 minutes for the
condensation to clear before
vacuuming again.
Getting Started: Vacuum and Steam Panel
Getting Started: Vacuum Mode
OPERATING IN VACUUM MODE:
1
Remove Steam pad and frame,
if attached. See page 8 for
instructions. Vacuum will not activate
if steam frame is attached.
instructions. Vacuum will not activate
if steam frame is attached.
2
SLIDE THE TOGGLE SWITCH UP to
expose the Vacuum Power button.
expose the Vacuum Power button.
3
Press the
VACUUM POWER BUTTON
to the on position to activate
the vacuum.
the vacuum.
OPERATING IN STEAM MODE:
1
Attach Steam Pad and Frame.
Steam mode will not work if the pad
and frame are NOT attached. See
page 8 for assembly instructions.
and frame are NOT attached. See
page 8 for assembly instructions.
2
Fill the that water tank.
SLIDE THE TOGGLE SWITCH DOWN
to expose the Steam Power button
to expose the Steam Power button
3
Press the
STEAM POWER BUTTON
to turn to the
ON position. The
button will be illuminated red when
steam mode is activated.
steam mode is activated.
4
Wait 30 seconds to heat water to
the 212° sanitizing temperature,
TILT HANDLE BACK TO ACTIVATE
STEAM PUMP.
the 212° sanitizing temperature,
TILT HANDLE BACK TO ACTIVATE
STEAM PUMP.
USING VACUUM MODE
1
Pull and twist the quick release cord
holder to unwrap the power cord
completely. Plug in the unit.
completely. Plug in the unit.
2
To vacuum, slide the toggle switch
until the Vacuum Power button is
exposed. Press the Vacuum Power
Mode button to the
exposed. Press the Vacuum Power
Mode button to the
ON position.
IMPORTANT: You can not use the
vacuum function if the frame and
pad are attached to the base of the
cleaning unit.
vacuum function if the frame and
pad are attached to the base of the
cleaning unit.
NOTE: Vacuum only sealed and non-
carpeted bare floor surfaces. Refer
to floor manufacturer guidelines and
warnings.
carpeted bare floor surfaces. Refer
to floor manufacturer guidelines and
warnings.
Your complete bare-floor cleaning and
sanitizing system with Shark® steam
technology has two operating modes:
sanitizing system with Shark® steam
technology has two operating modes:
After inserting the Telescopic Handle,
your cleaning system is vacuum-ready.
You can begin vacuuming your hard-
surface floors by tilting the cleaning unit
back and pressing the Vacuum Power
button.
your cleaning system is vacuum-ready.
You can begin vacuuming your hard-
surface floors by tilting the cleaning unit
back and pressing the Vacuum Power
button.
1
2
3
1
1
2
2
3
3
VACUUM MODE:
STEAM MODE: