Hoshizaki KM-1301SAH-E 사용자 설명서
42
b) Mechanical Bin Control Cleaning
Scale may build up on the mechanical bin control. Scale can cause the actuator paddle
and magnet to stick. In this case, the mechanical bin control should be cleaned.
and magnet to stick. In this case, the mechanical bin control should be cleaned.
WARNING
CHOKING HAZARD: Ensure all components, fasteners, and thumbscrews are
securely in place after the unit is serviced. Make sure that none have fallen into
the storage bin.
securely in place after the unit is serviced. Make sure that none have fallen into
the storage bin.
1) Turn off the power supply.
2) Remove the front panel, then move the control switch to the "OFF" position.
3) Clear any ice away from the mechanical bin control.
4) Disconnect the bin control cable connector, then remove the mechanical bin control
2) Remove the front panel, then move the control switch to the "OFF" position.
3) Clear any ice away from the mechanical bin control.
4) Disconnect the bin control cable connector, then remove the mechanical bin control
assembly from the unit.
5) Remove the actuator paddle from the switch mount. See Fig. 2.
6) Wipe down the mechanical bin control assembly with a mixture of 1 part Hoshizaki
6) Wipe down the mechanical bin control assembly with a mixture of 1 part Hoshizaki
"Scale Away" and 25 parts warm water. Rinse the parts thoroughly with clean water.
7) Reassemble the mechanical bin control assembly and replace it in its correct position.
Note: If the magnet was removed for cleaning, be sure to replace it in its correct
position.
8) Reconnect the bin control cable connector.
9) Move the control switch to the "ICE" position.
9) Move the control switch to the "ICE" position.
10) Replace the front panel in its correct position.
11) Turn on the power supply to start the automatic icemaking process.
11) Turn on the power supply to start the automatic icemaking process.
Fig. 2
Bin Control Cable Connector
Bin Control Bracket
Actuator Paddle
Switch Mount
Magnet