Philips MCM302/12 사용자 설명서

다운로드
페이지 24
5
This ‘bolt of lightning’ indicates uninsulated 
material within your unit may cause an electrical 
shock. For the safety of everyone in your 
household, please do not remove product 
covering. 
The ‘exclamation point’ calls attention to 
features for which you should read the enclosed 
literature closely to prevent operating and 
maintenance problems. 
WARNING: To reduce the risk of fi re or electric 
shock, this apparatus should not be exposed to 
rain or moisture and objects fi lled with liquids, 
such as vases, should not be placed on this 
apparatus. 
CAUTION: To prevent electric shock, match 
wide blade of plug to wide slot, fully insert. 
Warning
Never remove the casing of this unit. 
Never lubricate any part of this unit.
Place this unit on a fl at, hard and stable surface.
Never place this unit on other electrical equipment.
Only use this unit indoors. Keep this unit away from 
water, moisture and liquid-fi lled objects.
Keep this unit away from direct sunlight, naked fl ames 
or heat. 
Never look into the laser beam inside the unit.
Hearing safety
Listen at a moderate volume.
Using headphones at a high volume can 
impair your hearing. This product can 
produce sounds in decibel ranges that may 
cause hearing loss for a normal person, 
even for exposure less than a minute. The 
higher decibel ranges are offered for those 
that may have already experienced some 
hearing loss.
a  Remove fuse cover and fuse.
b  Fix new fuse which should be a BS1362 5 
Amp, A.S.T.A. or BSI approved type.
c  Refi t the fuse cover.
If the fi tted plug is not suitable for your socket 
outlets, it should be cut off and an appropriate 
plug fi tted in its place. 
If the mains plug contains a fuse, this should 
have a value of 5 Amp. If a plug without a fuse 
is used, the fuse at the distribution board should 
not be greater than 5 Amp. 
Note: The severed plug must be disposed off 
to avoid a possible shock hazard should it be 
inserted into a 13 Amp socket elsewhere.
How to connect a plug
The wires in the mains lead are coloured with 
the following code: blue = neutral (N), brown 
= live (L).
As these colours may not correspond with the 
colour markings identifying the terminals in your 
plug, proceed as follows:
Connect the blue wire to the terminal 
marked N or coloured black. 
Connect the brown wire to the terminal 
marked L or coloured red.
Do not connect either wire to the earth 
terminal in the plug, marked E (or e) or 
coloured green (or green and yellow).
Before replacing the plug cover, make certain 
that the cord grip is clamped over the sheath of 
the lead - not simply over the two wires.
Copyright in the U.K.
Recording and playback of material may require 
consent. see Copyright Act 1956 and The 
performer’s Protection Acts 1958 to 1972.
Know these safety symbols  
English
EN