Brother MFC-4300 사용자 설명서

      I N I T I A L   S E T U P

Please carefully read “Setting the Handset Volume” before you do the following 
steps:

Press 

,

,

,

. 

Press 

 or 

 to select 

VOL AMPLIFY:OFF? if none of the users 
are hearing-impaired, and then go to Step 4.
—OR—
If some or all of the users are hearing-
impaired, select VOL AMPLIFY:ON?. 

If all the users are hearing-impaired, press 

 or 

 to select PERMANENT?, and 

then press 

 

—OR— 
If only some of the users are hearing-impaired, select TEMPORARY?, and 
then press 

. 

Press 

 to exit.

You can adjust the speaker volume of your MFC. First press 

, then press 

 or 

 to select a speaker volume level.

When you press 

 or 

 to adjust the volume level, the LCD shows the setting 

you are choosing.  Each key press changes the volume to the next level. The new 
setting will remain until you change it again.

You can adjust the ring volume when your MFC is idle. You can turn the ring 
off or you can select a ring volume level. 

As you press 

 or 

 to adjust the volume level, the MFC rings so you can hear 

the volume for the level shown on the LCD.  Each key press changes the volume 
to the next setting.  The new setting will remain until you change it again.

In the event of a power failure, all settings in the INITIAL SETUP, SETUP 
RECEIVE, SET AUTO DIAL, and REMOTE FAX OPT functions plus the 
COVERPG SETUP and COVERPG MSG (from SETUP SEND) functions are 
stored permanently. You may have to reset the date and time.

SELECT <- -> & SET

VOL AMPLIFY:OFF?

SELECT <- -> & SET

PERMANENT?