Vermont Casting SDDVRBD 사용자 설명서
7
Stardance Direct Vent - Rear Vent Gas Heaters
20012950
ST128a
SDVR
flue centerline
10/9/00 djt
C
L
18���"
(476mm)
2���"
(63mm)
�
"
(102 mm)
�
"
(102 mm)
ST128a
Parallel Installation: Minimum Clearance
and Flue Centerline
Fig. 3 Parallel installation, minimum back and side clearance.
ST129a
stardance
corner specs
10/9/00 djt
Max. Vent
Length
20" (508mm)
7¹⁄₂"
(190mm)
2" (50mm)
2"
(50mm)
ST129a
Corner Installation: Minimum Clearance
and Flue Centerline
Fig. 4 Corner installation, minimum corner clearance and flue
centerline.
centerline.
ST381a
SDVR
clearance diagram
10/9/00 djt
9"
(230mm)
Max. Mantel
Width
See
Fig. 6
6"
(150mm)
Sidewall/
Trim
2���"
(63mm)
Rear Wall
ST381a
Wall and Ceiling Clearances
Fig. 5 Clearances to ceiling or alcoves.
Mantel Clearances
Noncombustible
Materials
ST382
Pinnacle
mantel clearances
6/13/00 djt
A
B
3" (75mm) Min.
ST382
A = Depth of Mantel and/or Top Trim
B = Height from Top of Heater
B = Height from Top of Heater
A (Max.)
B (Min.)
9”
10¹⁄₂”
(230 mm)
(270 mm)
7¹⁄₂”
9”
(190 mm)
(230 mm)
6”
7¹⁄₂”
(152 mm)
(190 mm)
4¹⁄₂”
6”
(114 mm)
(152 mm)
3”
4¹⁄₂”
(76 mm)
(114 mm)
1¹⁄₂”
3”
(38 mm)
(76 mm)
Fig. 6 Mantel / top trim clearances.
Combustible
Mantel or Trim
Materials
Hearth Requirements
The Stardance Heater must be installed on rigid floor-
ing. When the heater is installed directly on any com-
bustible surface other than wood flooring, a metal or
wood panel extending the full width and depth of the
unit must be used as the hearth. There are no other
hearth requirements.
ing. When the heater is installed directly on any com-
bustible surface other than wood flooring, a metal or
wood panel extending the full width and depth of the
unit must be used as the hearth. There are no other
hearth requirements.