Husqvarna 326C 사용자 설명서

12

 – English

!

• Clip the loop handle onto

the shaft. Note that the
loop handle must be fitted
between the arrows on the
shaft.

• Slide the spacer into the

slot in the loop handle.

• 326L

X-series

: Fit the nut,

knob and bolt. Do not
overtighten.

• Now adjust the trimmer to

give a comfortable working
position. Tighten the bolt/
knob.

• Position the handle on the

shaft. Note that the handle
must be mounted below
the arrow on the shaft.

• Fit the bolt, securing plate

and wing nut as shown in
the diagram.

• Tighten the wing nut.

It is extremely important that
the disc drive’s/support
flange’s guide engages
correctly in the cutting
equipment’s centre hole
when assembling the cutting
equipment. Cutting
equipment assembled
incorrectly can result in
serious and/or fatal personal
injury.

• Make sure the handle is

loose.

• Guide the cut-out on the

lower section of the shaft
into the coupling‘s
locking plate on the
upper section of the
shaft. The sections are
then locked together.

• Tighten the handle.

• Undo the handle (at least

three turns).

• Press the handle towards

the coupling.

• Carefully twist the lower

section out of the lock.

• Hold both parts of the

shaft and pull out the
lower section from the
coupling.