Ricoh SP 3300D 사용자 설명서

4.1   

<Network setup (SP 3300DN only)>

This chapter gives you basic information for setting up your printer for 
network connections.

This chapter includes:

Once you have connected your printer to a network with an RJ-45 
Ethernet cable, you can share the printer with other network users.

You need to set up the network protocols on the printer to use it as your 
network printer. Protocols can be set up by the following programs:

• Web Image Monitor SP 3300 Series: A web server embedded to 

your network print server, which allows you to configure the network 
parameters necessary for the printer to connect to various network 
environments.

• SetIP: A utility program allowing you to select a network interface and 

manually configure the addresses for use with the TCP/IP protocol. 
This program is on the supplied CD-ROM that comes with your 
printer.

The following table shows the network environments supported by the 
printer: 

• TCP/IP: Transmission Control Protocol/Internet Protocol
• DHCP: Dynamic Host Configuration Protocol
• BOOTP: Bootstrap Protocol

Network interface

• 10/100 Base-TX

Network operating 
system

• Windows 2000/XP (32/64 bit)/Vista and 

Windows Server 2003

• Mac OS 8.6~9.2, 10.1~10.5

Network protocols

• TCP/IP
• EtherTalk
• HTTP  1.1
• SNMP
• Bonjour

Dynamic 
addressing server

• DHCP, BOOTP

This program is for the network IP setting using the MAC address which 
is the hardware serial number of the network printer card or interface. 
Especially, it is for the network administrator to set several network IPs 
at the same time. 

Insert the supplied CD-ROM provided along with your machine. 

Start Windows Explorer and open the X drive. (X represents your 
CD-ROM drive.)

Double click Application > SetIP.

Open the language folder you want to use.

Double click Setup.exe to install this program. 

From the Windows Start menu, select Programs > SP 3300 Series 
> Set IP.

Select the name of your printer and click “ 

 ”. 

Enter the network card’s MAC address, IP address, subnet mask, 
default gateway, and then click Apply.

Click OK to confirm the settings.

10 Click Exit to close the SetIP program.

If you want to setup DHCP network protocol, go to the 

, select 

the program Bonjour for Windows due to your computer 
operating system, and install the program. This program will 
allow you to fix the network parameter automatically. Follow 
the instruction in the installation window. 

If you cannot find your printer name click “ 

 ” to refresh the 

list.

If you do not know the network card’s MAC address, print the 
machine’s network information report.