Hoover u6439900 사용자 설명서
BRUSH ROLL
CARPET
HARD
ON OFF
2-9
Brush roll control
Note: When handle is in upright
position, brush roll is automatically
OFF.
position, brush roll is automatically
OFF.
Move the brush roll control only when
the handle is in the upright position.
the handle is in the upright position.
Slide control to “Carpet” to turn brush
roll ON for cleaning carpet or rugs.
roll ON for cleaning carpet or rugs.
Slide control to “Hard” to turn brush roll
OFF when cleaning bare floors.
OFF when cleaning bare floors.
CARPET HEIGHT
BRUSH ROLL
AUTOMATIC
BRUSH ROLL
ON OFF
ON OFF
Embedded Dirt FINDER
feature
feature
(some models only)
With red and green lights (A), the ‘Dirt
FINDER’ system alerts the user to areas
of carpet that may need more cleaning
attention. It is able to sense when larger
amounts of dirt particles, especially
embedded dirt, are removed.
FINDER’ system alerts the user to areas
of carpet that may need more cleaning
attention. It is able to sense when larger
amounts of dirt particles, especially
embedded dirt, are removed.
To let you know that the ‘Dirt FINDER’
feature is ready the red light will come on
when the cleaner is first turned on. After
a few seconds, the red light will go off
and the
feature is ready the red light will come on
when the cleaner is first turned on. After
a few seconds, the red light will go off
and the
green light
will come on.
Cleaning may then begin.
The
green light will remain on
through-
out cleaning
except
when the detector
senses that a
larger amount of dirt
is
being picked up; then the
red light
will
come on.
Handle positions
The handle of your cleaner has three
positions;
positions;
upright
for storage and when
using cleaning tools;
operating posi-
tion
for general operation on carpet
and floors;
low
for reaching under low
furniture.
Step on handle release lever to lower
handle.
handle.
Carrying cleaner
The cleaner can be moved by using
the carrying handle located on the back
of the cleaner.
the carrying handle located on the back
of the cleaner.
6
CARPET HEIGHT
BRUSH ROLL
AUTOMATIC
BRUSH ROLL
ON OFF
ON OFF
2-7
2-5
2-6
A
B
(Fig. 2-7 continued)
When the
red light
is on, you should
take additional cleaning strokes
in the
area until it changes to green.
•The red light may seldom come on
during cleaning. This means that your
cleaner is picking up primarily fine sur-
face dust and lint which the system may
not detect, or that the carpet is general-
ly clean.
during cleaning. This means that your
cleaner is picking up primarily fine sur-
face dust and lint which the system may
not detect, or that the carpet is general-
ly clean.
To increase
the feature’s
sen-
sitivity to dirt
, set the switch (B) to the
“Hi”
position.
•At other times, the red light may stay
on for a considerable amount of time.
This means that the carpet contains a
high level of dirt which is being
removed by the cleaner.
on for a considerable amount of time.
This means that the carpet contains a
high level of dirt which is being
removed by the cleaner.
To decrease
the feature’s
sensitivity to dirt
, set the
switch to the
“Reg.”
(Regular) position.
Carpet height
adjustment
adjustment
When it is necessary to raise and lower
the front of the cleaner for various car-
pet pile heights, slide the carpet height
control (C) to the desired setting.
the front of the cleaner for various car-
pet pile heights, slide the carpet height
control (C) to the desired setting.
For maximum cleaning performance,
the following carpet height settings are
recommended:
recommended:
• Low setting: for all types of carpet
• Higher settings: for very deep pile
carpet where easier pushing effort is
desired, while maintaining good clean-
ing performance.
carpet where easier pushing effort is
desired, while maintaining good clean-
ing performance.
Note: If the cleaner is difficult to push,
slide control to the next higher setting.
slide control to the next higher setting.
C
2-8
TM