Datamax m-class mark ii 사용자 가이드
Chapter 4 – Menu System
41
Communications
The Communications menu contains interface and host control functions:
Serial Port A
Parallel Port A
NIC Adapter (Ethernet)
Host Settings
The menu selections are defined as follows:
DISPLAYED ITEM
ITEM DESCRIPTION
SERIAL PORT A
Controls the RS-232 communications settings for Serial Port A, where:
BAUD RATE
Sets the serial communication rate, where:
(1200 –
115000 BPS)
9600 BPS
Is the range, in Bits Per Second; and,
is the Default Setting.
PROTOCOL
Sets the data flow control (handshaking) method, where:
BOTH XON/XOFF
and
CTS/DTR
are used. (Default Setting)
SOFTWARE XON/XOFF
is
used.
HARDWARE
CTS/DTR is used.
NONE
Flow control is not used.
PARITY
Sets word parity, where:
NONE
Parity is not used. (Default Setting)
ODD Odd
parity
is
used.
EVEN
Even parity is used.
DATA BITS
Sets word length, where:
(7 - 8)
8
8
A seven or eight bit word is selectable; and,
is the Default Setting.
is the Default Setting.
STOP BITS
Sets the number of stop bits, where:
(1 - 2)
1
1
One stop or two stop bits are selectable; and,
is the Default Setting.
is the Default Setting.
PARALLEL PORT A
Controls the communication setting for the parallel port, where:
PORT
DIRECTION
DIRECTION
Determines if data is returned from the printer, where:
UNI-
DIRECTIONAL
No data is returned; communication is one-way.
BI-
DIRECTIONAL
Data is returned in compliance with IEEE 1284 back-channel operation. (Default
Setting)
An IEEE 1284 bidirectional cable is required.
NIC ADAPTER
Controls the communications settings for the network interface, where:
If a wireless card is installed, this port is automatically disabled;
to enable the wired LAN connection, disable the Wireless Ethernet
MODE setting (see below).
QUICK SETUP
Controls the communications settings for the network interface, where:
WIRED DHCP
Configures the card for wired connection.
WLAN
UNSECURED
Configures the card for wireless connection, with SSID of “any”
WLAN ADHOC Configures the card for wireless connection, AdHoc mode.
SET FACTORY
SET FACTORY
DEFAULTS
Resets NIC Adapter parameters to the factory defaults values.