Datamax e-4205e 사용자 가이드

 

 

The Hex Dump Label is a useful tool in the diagnosis of problems including communications handshaking and 

DPL syntax errors. To generate a Hex Dump Label the printer enters into Hex Dump Mode. In this mode, all 

data sent to the printer will be immediately output in hexadecimal code, along with the printable ASCII 

equivalents. To decode this information, the Class Series Programmer’s Manual is an essential reference. As a 

final note, many software programs use bit mapping to construct the label, making diagnosis of this data 

difficult. Contact Datamax-O’Neil Technical Support with any questions. 

 

With the printer off, loaded with media (at least 4 inches wide) and ribbon (if printing with thermal transfer 

media), press and hold the 

F2

 button while turning the printer on. Continue holding the 

F2

 button until the 

PAUSED Light turns off. Now, all data received by the printer will be output in hexadecimal code, as shown 

below. 

 

 

 
 

To exit the Hex Dump Mode, turn the printer off.