Bosch HES5053U 사용자 가이드

다운로드
페이지 100
English 24
Plastic or foods with a high sugar content:
These types of soils need be removed immediately if 
spilled or melted onto the ceramic cooktop surface. 
Permanent damage (such as pitting of the cooktop surface) 
may occur if not removed immediately
After turning the surface elements OFF, use a razor blade 
scraper or a metal spatula with a mitt and scrape the soil 
from the hot surface (as illustrated). Allow the cooktop to 
cool, and use the same method for heavy or burned on 
soils.
Do not use the following on the cooktop:
Do not use abrasive cleaners and scouring pads, such 
as metal and some nylon pads. They may scratch the 
cooktop, making it more difficult to clean.
Do not use harsh cleaners, such as chlorine bleach, 
ammonia or oven cleaners, as they may etch or 
discolor the cooktop. 
Do not use dirty sponges, cloths or paper towels, as 
they can leave soil or lint on the cooktop  which can 
burn and cause discoloration. 
Caution for aluminum use on the cooktop
Aluminum Foil - Use of aluminum foil on a hot cooktop 
will damage the ceramic cooktop. Do not use thin 
aluminum cooking utensils or allow aluminum foil to 
touch the ceramic cooktop under ANY circumstances.
Aluminum utensils - The melting point of aluminum is 
much lower than that of other metals. Care must be 
taken when aluminum pots or pans are used on the 
cooktop. If aluminum pans are allowed to boil dry when 
using the cooktop, not only will the utensil be 
destroyed, but it may fuse to, break or mark the 
ceramic glass surface, permanently damaging the 
cooktop surface.
Maintenance
Replacing an Oven Light
The light bulb is located at the rear of the oven and is 
covered with a glass shield held by a wire holder. The glass 
shield must be in place whenever the oven is in use.
To replace the oven light bulb:
1. Turn electrical power off at the main source or unplug 
the range.
2. Press wire holder to one side to release the glass 
shield.
3. Replace bulb with a new 40 watt appliance bulb.
4. Replace glass shield over bulb and snap wire holder 
into place.
5. Turn power back on again at the main source (or plug 
in the range back in).
6. The clock will then need to be reset. To reset, see 
Setting the Clock and Minute Timer in this Use and 
Care Guide.
CAUTION:
Make sure the appliance and lights are 
cool and power to the appliance has been 
turned off before replacing the light 
bulb(s). Failure to do so could result in 
electrical shock or burns.
Be sure the range is unplugged and all 
parts are COOL before replacing light. 
Wear a leather-faced glove for protection 
against possible broken glass.