Bosch ra1171 router table 사용자 설명서

다운로드
페이지 96
Router Table Assembly
ATTACHING THE SWITCH TO THE 
TABLETOP (Fig. 3)
Assembly Hint: It may be easier to attach the switch
bracket if you stand the tabletop on its back edge for
this step.
1. Align the two holes in the switch mounting bracket
(15) with the two through-holes in the router tabletop.
From the top side of the table, insert two #10-32 x
1
1
2
″ pan-head machine screws (34) through the
tabletop and bracket and secure the bracket in place
with two small washers (30) and two #10-32 KEPS
nuts (29) (Fig. 3).
2. Insert two #10-32 KEPS nuts (29) into the 
hex-shaped recesses in the back of the switch
assembly (14) with the toothed washer facing away
from the recess. Secure the switch to the switch
mounting bracket with two #10-32 x 1/2
″ pan-head
machine screws (33) while holding the KEPS nuts in
place in the recess with your finger.
11
34
15
14
29
29
33
FIG. 3
DETAIL 3
ATTACH THE TABLETOP (Fig. 4)
NOTE: The tabletop may be shipped with the miter
channel in place. To access the tabletop mounting
holes, remove the channel for this step.
1. With the base assembly upright, position the 
tabletop (1) on the base assembly, making sure 
the switch is in the front, as shown in Fig. 4. 
2. Secure the tabletop to the base with four Allen-head 
connector screws (38). 
3. Tighten all fasteners securely with the 4mm hex key.
The screw head should be in the counterbore, below
the panel surface. DO NOT OVERTIGHTEN!
1
38
FIG. 4
ASSEMBLE THE ALUMINUM MITER
CHANNEL TO THE TABLETOP (Fig. 5)
Assembly Hint: It may be easier to install the miter
channel if you lay the table on its back for this step.
1. Center the miter channel (2) in the slot on the 
tabletop; then press the miter channel into the slot.
2. From the top side of the tabletop (1), insert three
#10-32 x 7/8
″ countersunk Phillips machine screws
(36) through the holes in the miter channel (2) and
the tabletop (Fig. 5). 
3. Secure with a small washer (30) and a #10-32 KEPS
nut (29) on each screw. 
36
30
29
2
FIG. 5
14
30