Alcatel-Lucent 6850-48 네트워크 가이드
Configuring VLAN Stacking
Configuring VLAN Stacking Services
OmniSwitch AOS Release 6 Network Configuration Guide
September 2009
page 9-13
-> ethernet-service svlan 300 disable
-> ethernet-service svlan 300 stp disable
-> ethernet-service svlan 300 name “Customer A”
To delete an SVLAN from the switch configuration, use the no form of the ethernet-service svlan
command. For example, to delete SVLAN 300 enter:
command. For example, to delete SVLAN 300 enter:
-> no ethernet-service svlan 300
Note that when an SVLAN is deleted, all port associations with the SVLAN are also removed.
Use the
command to display a list of VLAN Stacking VLANs configured for
the switch.
Configuring a VLAN Stacking Service
A VLAN Stacking service is identified by a name. The
command is used
to create a service and assign the service to an SVLAN or IMPVLAN ID, depending on the type of traffic
the service will process. The ID specified with this command identifies the SVLAN that will carry traffic
for the service. Each service is associated with only one SVLAN, but an SVLAN may belong to multiple
services.
the service will process. The ID specified with this command identifies the SVLAN that will carry traffic
for the service. Each service is associated with only one SVLAN, but an SVLAN may belong to multiple
services.
To create a VLAN Stacking service, use the ethernet-service service-name command and specify a name
and SVLAN or IPMVLAN ID. For example, the following command creates a service named “Video-
Service” and associates the service with SVLAN 300:
and SVLAN or IPMVLAN ID. For example, the following command creates a service named “Video-
Service” and associates the service with SVLAN 300:
-> ethernet-service service-name Video-Service svlan 300
The SVLAN or IPMPVLAN ID specified with this command must already exist in the switch configura-
tion; entering a standard VLAN ID is not allowed. See
tion; entering a standard VLAN ID is not allowed. See
for more
information.
Once the VLAN Stacking service is created, the name is used to configure and display all components
associated with that service. The service name provides a single point of reference for a specific VLAN
Stacking configuration. For example, the following
associated with that service. The service name provides a single point of reference for a specific VLAN
Stacking configuration. For example, the following
command display shows how
the service name identifies a VLAN Stacking service and components related to that service:
-> show ethernet-service
Service Name : Video-Service
SVLAN : 300
NNI(s) : 2/1, 3/2
SAP Id : 20
UNIs : 1/1, 1/2
CVLAN(s) : 10, 20
sap-profile : sap-video1
SAP Id : 30
UNIs : 1/3
CVLAN(s) : untagged, 40
sap-profile : sap-video2
Service Name : ipmv_service
IPMVLAN : 40
NNI(s) : No NNIs configured
SAP Id : 2
UNIs : 1/22
CVLAN(s) : 100
sap-profile : translate_profile