Biostar 200t-m-e1 부록 매뉴얼
P4TBA BIOS Setup
17
USB Keyboard/Mouse Support
This item allows you to enable or disable the USB Keyboard/ Mouse Legacy
Support.
This item allows you to enable or disable the USB Keyboard/ Mouse Legacy
Support.
The Choices: Disabled (default),
Enabled
AC97 Audio/ Modem
This item allows you to decide to enable/ disable to support AC97
Audio/Modem.
Audio/Modem.
The Choices: Auto (default), Disabled.
Onboard PCI LAN
This item allows you to enable or disable the onboard PCI LAN.
The Choices: Enabled (Default), Disabled.
Onboard LAN Boot ROM
This item helps to decide whether to invoke the boot ROM of the onboard LAN
Chip.
The Choices: Enabled (Default), Disabled.
Onboard PCI LAN
This item allows you to enable or disable the onboard PCI LAN.
The Choices: Enabled (Default), Disabled.
Onboard LAN Boot ROM
This item helps to decide whether to invoke the boot ROM of the onboard LAN
Chip.
The Choices: Enabled (Default), Disabled.
Onboard I/O Device
Power on Function
This item allows you to choose Power On Function.
The Choices: Button only (default), Password, Hot Key, Mouse Move, Mouse
Click, Any key, Remote IR.
Keyboard Power on Password
This item allows you to choose Power On Function.
The Choices: Button only (default), Password, Hot Key, Mouse Move, Mouse
Hot Key Power On
Input password and press Enter to set the Keyboard power on password .
The Choices: Ctrl-F1(default) , Ctrl-F2 , Ctrl-F3 , Ctrl-F4 , Ctrl-F5,
Ctrl-F6 , Ctrl-F7 , Ctrl-F8
Onboard FDC Controller
This item allows you to choose Power On Function.
The Choices: Button only (default), Password, Hot Key, Mouse Move, Mouse
Click, Any key, Remote IR.
Keyboard Power on Password
This item allows you to choose Power On Function.
The Choices: Button only (default), Password, Hot Key, Mouse Move, Mouse
Hot Key Power On
Input password and press Enter to set the Keyboard power on password .
The Choices: Ctrl-F1(default) , Ctrl-F2 , Ctrl-F3 , Ctrl-F4 , Ctrl-F5,
Ctrl-F6 , Ctrl-F7 , Ctrl-F8
Onboard FDC Controller
Select Enabled if your system has a floppy disk controller (FDC) installed on the
system board and you wish to use it. If install and FDC or the system has no
floppy drive, select Disabled in this field.
The Choices: Enabled (default), Disabled.
Onboard Serial Port 1
system board and you wish to use it. If install and FDC or the system has no
floppy drive, select Disabled in this field.
The Choices: Enabled (default), Disabled.
Onboard Serial Port 1
Select an address and corresponding interrupt for the first and second serial ports.
The Choices: 3F8/IRQ4 (default), Disabled, Auto, 2F8/IRQ3,
3E8/IRQ4, 2E8/IRQ3.