Fujitsu fi-4120C 설치 설명서
Fujitsu USB
Scanner Installation Procedures
with VRS
Windows 2000 / XP
Rev010807L
Page 1 of 2
This document is intended for installations of the following products with VRS using the
USB interface connection.
FI-4120C\C2
Fi-4340C
Fi-5220C
Fi-5750C
Fi-4220C\C2
Fi-4530C
Fi-5530C
Fi-5900C
Fi-5120C Fi-5650C
Hardware requirements.
You will need a PC system that meets both Fujitsu’s and Kofax’s recommended
specifications. For recommended PC system specifications please reference the
You will need a PC system that meets both Fujitsu’s and Kofax’s recommended
specifications. For recommended PC system specifications please reference the
page. You may also need your Operating System Disk.
Step A: Installing the VRS drivers.
First boot your PC and install the Kofax VRS driver that shipped with the scanner.
Special note: When installing the VRS driver and any other software that contains
Kofax’s Image Controls pay close attention to the individual runtimes. It is strongly
recommended that you install the oldest/lower runtime application first.
Step B: Unlocking the shipping lock.
If your model scanner does not have a flatbed then proceed to Step D.
The flatbed model scanners typically include a lock on the flatbed designed to
protect the scanner during shipment. Before the scanner can be used the
shipping lock must be unlocked. To unlock it do the following:
1. Located the shipping lock slider tab or knob underneath the end of the
shipping lock must be unlocked. To unlock it do the following:
1. Located the shipping lock slider tab or knob underneath the end of the
scanner.
2. Slide or rotate the lock to the unlock position.
Step C: Connecting the Scanner.
Connect the USB cable to the both the Scanner and the PC. For the Fi-5900C
connect the USB cable to the VRS USB port. Ensure all connections are
securely fastened.
Connect the power cord to the scanner and a wall outlet. Boot up your PC first
and then turn on the scanner. Complete the new hardware found wizard and go
to the next step.
connect the USB cable to the VRS USB port. Ensure all connections are
securely fastened.
Connect the power cord to the scanner and a wall outlet. Boot up your PC first
and then turn on the scanner. Complete the new hardware found wizard and go
to the next step.