Fujitsu S510M 사용자 가이드
ScanSnap S510M for Mac Getting Started | 5
1. Preparation
This chapter describes necessary preparations before using
ScanSnap.
ATTENTION
Do not connect the scanner to your personal
computer before installing “ScanSnap Manager.”
If you connect the scanner before installing
ScanSnap Manager, it will not operate correctly.
Refer to Chapter 2 for details on the installation of
ScanSnap Manager.
computer before installing “ScanSnap Manager.”
If you connect the scanner before installing
ScanSnap Manager, it will not operate correctly.
Refer to Chapter 2 for details on the installation of
ScanSnap Manager.
1.1. Checking the Contents of the
Package
When you unpack the scanner package, make sure that all
parts are included.
Refer to the packing list included in the scanner package
for contents.
parts are included.
Refer to the packing list included in the scanner package
for contents.
1.2. Name and Function of Parts
This section describes the name and function of parts.
Front Side
* You can also use the scanner without the Stacker.
Buttons
Back Side
HINT
For the Document Specifications, refer to the
“ScanSnap S510M for Mac Operator’s Guide”
stored in ScanSnap Setup CD-ROM.
“ScanSnap S510M for Mac Operator’s Guide”
stored in ScanSnap Setup CD-ROM.
ATTENTION
The scanner turns on/off automatically when you
open/close the Paper chute.
To turn off the scanner with the cover opened,
press the [POWER] button.
open/close the Paper chute.
To turn off the scanner with the cover opened,
press the [POWER] button.
Paper chute
Open the paper chute to use
the scanner.
Open the paper chute to use
the scanner.
Ö
Opening the paper chute
turns ON the scanner.
Stacker
Extend this part to use the stacker
as shown in the figure.
Extend this part to use the stacker
as shown in the figure.
Ö
Sheets of paper are ejected from the ADF onto the stacker.
Cover open lever
Pull this lever to open the ADF.
Pull this lever to open the ADF.
Paper chute
Open the paper chute and load
documents onto it for scanning
documents.
Side guide
Adjust these guides to fit the
width of the paper, so that the
paper does not skew.
Adjust these guides to fit the
width of the paper, so that the
paper does not skew.
Buttons
ADF
(ADF: Automatic Document
Feeder)
(ADF: Automatic Document
Feeder)
[SCAN] button
Start scanning.
Start scanning.
[POWER] button
Hold down 1 sec. to turn
on/off the power supply.
Hold down 1 sec. to turn
on/off the power supply.
Power lamp
Indicate the scanner status.
Blue (Solid): Ready
Blue (Blinking): Scanning
Orange: Error
Light out: Power
Blue (Solid): Ready
Blue (Blinking): Scanning
Orange: Error
Light out: Power
off
Seal: After installing
ScanSnap Manager onto
your computer, remove
this seal to connect the
scanner to the PC.
your computer, remove
this seal to connect the
scanner to the PC.
AC adapter connector
USB connector
Security cable slot
Plug a commercially
available security cable
into this slot (anti-theft).
Plug a commercially
available security cable
into this slot (anti-theft).