LG lrm-519 사용자 가이드

72

Issue
Channels do not change 

with the serial data control 

cable connected.

Solution
Restart both the satellite set-top box and the Recorder. If this channels 

still do not change, use the IR control cable instead.

Some satellite set-top boxes support the use of the serial data 

control cable to change channels and the IR control cable. However, 

not all of theses specific satellite set-top boxes enable the serial input 

port. For more information, check with the set-top box manufacturer.

Before you connect the serial data control cable, make sure the 

power cord for the Recorder and the power cord for the satellite 

setBefore you connect the serial data control cable, make sure the 

power cord for the Recorder and the power cord for the satellite set-

top box are not plugged into a power outlet or power strip.

The Recorder supports serial data control by using the Serial-APG  

and Serial-MPG serial data control protocols. Check with the set-top 

box manufacturer or satellite service provider to make sure your 

satellite set-top box uses this standard.

For more information, see The IR control cable and the Serial Data 

Control Cable.

The message “<TV show> 

cannot be recorded 

because there are too 

many recorded shows” 

appears. 

The Recorder disk drive contains too many recorded TV shows and 

there is not enough disk space to record the current show. Go to 

Recorded TV and delete some recorded shows, or add a USB device for 

additional storage. For information about adding a USB device, see Add 

Additional Storage.

Pictures and Music from 

other computers are not 

available. 

To display pictures and play music stored on a computer, the computer 

and the Recorder must be connected to the same network and the 

computer must be running Window Media Connect.
If these two conditions are met, check the following:

Make sure both the computer and the Recorder have network access. 

For example, try downloading the Guide listings on the Recorder and 

open a browser window on the computer.

The computer must be turned on.

Open Windows

®

 Media Connect and make sure the Recorder is listed 

as a recognized device.

For more information, see Windows

®

and Music Stored on a Computer.

Cannot record a DVD 

from a DVD player to the 

Recorder. 

You cannot connect a DVD player and then copy a DVD to the 

Recorder. For more information, see Copying of Commercial/Retail 

Copyrighted DVDs.

The Recorder plays a 

sample video repeatedly. 

The Recorder may be in Demonstration mode. To end Demonstration 

mode, unplug the power cord from the back of the Recorder, wait five 

seconds, and then re-attach the power cord to the Recorder while press 

OPEN/CLOSE on the front panel.