Fantom Drives mgd-16fc16a 사용자 가이드
FIBRE-to-SAS/SATA RAID SUBSYSTEM
160
User Manual
12. To verify the IP address of controller using LCD panel, press the
button
several times until you see the Controller IP menu. This menu displays the
Controller IP address. Pressing the
Controller IP address. Pressing the
button will display second controller’s IP
address (will show 0.0.0.0 if there is no second controller).
NOTE: The LCD will display the IP address 2 minutes after power
on, and subsequently refreshed every 15 minutes.
If the IP address is changed or reconfigured, the LCD will
show the updated IP address within 15 minutes.
show the updated IP address within 15 minutes.
IMPORTANT!
ProSES board PRO-90-6601 will not show in the LCD the
controller’s IP address after upgrading the firmware to the
web GUI version (controller FW 1.30, expander FW V389,
and proSES FW 1.18).
controller’s IP address after upgrading the firmware to the
web GUI version (controller FW 1.30, expander FW V389,
and proSES FW 1.18).
If proSES board is PRO-90-5601, the LCD will display the
controller’s IP address after upgrade.
controller’s IP address after upgrade.
13. For PRO-90-6601 SES board, to see the controller IP address, connect phone-
jack-to-DB9 serial cable to the controller’s RS232 port and to your computer’s
COM port. Then start terminal session with settings as follows: Bits per second:
115200, Data bits: 8, Parity: None, Stop bits: 1, and Flow Control: None. After
connecting, login as “netadmin” without password. The screen will show the
current IP setting.
COM port. Then start terminal session with settings as follows: Bits per second:
115200, Data bits: 8, Parity: None, Stop bits: 1, and Flow Control: None. After
connecting, login as “netadmin” without password. The screen will show the
current IP setting.