RCA drd515rb 사용자 가이드

In order for the satellite receiver and VCR to communicate, you

need to attach the VCR Controller to the back of the receiver.

1.

Plug the VCR Controller into the VCR CONTROL jack on the

back of the receiver.

2.

Affix the other end to the remote sensor on your VCR.

The VCR Controller must be affixed directly over the infrared

remote sensor on your VCR.

Some VCRs label the infrared remote sensor, and others do not.

If your VCR is labeled, affix the VCR controller directly over the

sensor.

Using the VCR Remote to Locate the Remote
Sensor

For VCRs that do not label the remote sensor, you need to use

the VCR’s remote to locate the sensor before affixing the VCR

controller.

1.

Hold the remote control so that it is touching the front of

the VCR.

2.

Slowly move the remote over the front of the VCR while

pressing the remote power button on and off.

3.

When your VCR turns off or on, you have located the sensor.

To test the VCR controller, use a piece of clear tape to

temporarily attach the VCR controller to the spot where you

think the sensor is located, and then follow the steps described

under “Selecting a VCR Type.”

OUT

TO
TV

IN

FROM

ANT

S-VIDEO

VIDEO

R

L

AUDIO

VCR CONTROL

SATELLITE IN

LOW SPEED DATA

PHONE JACK

CH3

CH4

REMOTE SENSOR

Back of Satellite Receiver

Front of VCR