Printronix SL4M 사용자 설명서
228
Appendix B
Using The Full Media Rewinder With 3 Inch Diameter Core Adapters
Figure 14. Installing the Outside Core Adapter
3.
Slide the outside core adapter onto the rewinder. Place it about 1/2 inch
further in than the width of the media take-up core you are going to use.
For example, if the media take-up core is 4 inches wide, the distance from
the rewinder flange to the outside edge of the outside core adapter should
be about 3 1/2 inches.
further in than the width of the media take-up core you are going to use.
For example, if the media take-up core is 4 inches wide, the distance from
the rewinder flange to the outside edge of the outside core adapter should
be about 3 1/2 inches.
4.
Tighten the thumbscrew.
Figure 15. Installing the Media Take-Up Core
5.
Slide a 3 inch diameter media take-up core onto the rewinder over the two
core adapters until it is flush with the rewinder flange. You should have
about 1/2 inch from the outside edge of the outside core adapter to the
edge of the media take-up core.
core adapters until it is flush with the rewinder flange. You should have
about 1/2 inch from the outside edge of the outside core adapter to the
edge of the media take-up core.
pgrw
lod3
Rewinder
Flange
Flange
Thumbscrew
Outside
Edge
Outside Core Adapter
Rewinder
pgrwlod4
pgrwlod5
B
B
Rewinder
Flange
Media
Take-Up
Core