Printronix l7032 참조 매뉴얼
114
Chapter
2
Command Codes
If the length is an odd number, the space for the
additional dots is provided but the dots are not
printed. For example, entering 0004 specifies a 0.0-
inch plus 4-dot row vertical line length; entering
0242 specifies a 2.4-inch plus 2-dot row vertical line
length, but the additional 2 dots are not printed. The
LD command is ignored if either length parameter
is zero plus zero dots.
additional dots is provided but the dots are not
printed. For example, entering 0004 specifies a 0.0-
inch plus 4-dot row vertical line length; entering
0242 specifies a 2.4-inch plus 2-dot row vertical line
length, but the additional 2 dots are not printed. The
LD command is ignored if either length parameter
is zero plus zero dots.
High Resolution:
Defines the vertical length of a line in thousandth
inches. Enter a five-digit vertical value ranging from
00000 through 99999 to define a vertical length of
0.000 inch through 99.999 inches. VGL
automatically understands the decimal between the
second and third digits.
Defines the vertical length of a line in thousandth
inches. Enter a five-digit vertical value ranging from
00000 through 99999 to define a vertical length of
0.000 inch through 99.999 inches. VGL
automatically understands the decimal between the
second and third digits.
NOTE: Even in High Resolution Mode, dashed lines are still "dashed" in
tenths-of-an-inch increments.
(cc)-
Graphics Mode CR. Enter the SFCC for your VGL
configuration immediately followed by - to end the
command sequence.
configuration immediately followed by - to end the
command sequence.
Comments
Line drawing commands are positioned by the parameters or
commands of an alphanumerics command sequence (such as
horizontal tabs, the justification parameter, etc.). Consequently,
an alphanumeric command must precede a line drawing
command.
commands of an alphanumerics command sequence (such as
horizontal tabs, the justification parameter, etc.). Consequently,
an alphanumeric command must precede a line drawing
command.
Using appropriate values for the horizontal and vertical line length
parameters constructs a variety of vertical and horizontal lines in
varying line thicknesses. The dashed line is produced by printing
the odd tenth inches of length only; the even tenth inches of
length are blanked. If the length ends in an even number (2.4" for
example), the last even tenth inch is blank, making the line
appear one-tenth inch too short. A 2.4" dashed line appears to be
the same length as a 2.3" dashed line due to the blanking of the
last even tenth inch.
parameters constructs a variety of vertical and horizontal lines in
varying line thicknesses. The dashed line is produced by printing
the odd tenth inches of length only; the even tenth inches of
length are blanked. If the length ends in an even number (2.4" for
example), the last even tenth inch is blank, making the line
appear one-tenth inch too short. A 2.4" dashed line appears to be
the same length as a 2.3" dashed line due to the blanking of the
last even tenth inch.
The vertical or horizontal orientation of the dashed line is
determined by the horizontal and vertical length parameters. If
the horizontal length parameter is the longest, a dashed
horizontal line is printed; conversely, if the vertical length
parameter is the longest, a dashed vertical line is printed. If the
horizontal and vertical line length parameters are equal, VGL
prints a horizontal dashed line.
determined by the horizontal and vertical length parameters. If
the horizontal length parameter is the longest, a dashed
horizontal line is printed; conversely, if the vertical length
parameter is the longest, a dashed vertical line is printed. If the
horizontal and vertical line length parameters are equal, VGL
prints a horizontal dashed line.