Printronix l7032 참조 매뉴얼
152
Chapter
2
Command Codes
dis
Normal Resolution:
Defines the horizontal tab in tenths of an inch plus
dot columns from the left margin. Enter a three-digit
value ranging from 000 through 999 to define a tab
from 00.0 through 99.9 inches from the left margin
and a fourth digit ranging from 0 through 9 to
specify 0 through 9 additional dot columns. VGL
automatically understands the decimal between the
second and third digits for tenth inches and
automatically interprets the fourth digit as dot
columns. For example, 0120 (or 012,0) specifies a
1.2-inch plus no-dot column tab; 1016 (or 101,6)
specifies a 10.1-inch plus 6-dot column tab.
Defines the horizontal tab in tenths of an inch plus
dot columns from the left margin. Enter a three-digit
value ranging from 000 through 999 to define a tab
from 00.0 through 99.9 inches from the left margin
and a fourth digit ranging from 0 through 9 to
specify 0 through 9 additional dot columns. VGL
automatically understands the decimal between the
second and third digits for tenth inches and
automatically interprets the fourth digit as dot
columns. For example, 0120 (or 012,0) specifies a
1.2-inch plus no-dot column tab; 1016 (or 101,6)
specifies a 10.1-inch plus 6-dot column tab.
High Resolution:
Defines the horizontal tab in thousandth inches.
Enter a five-digit horizontal value ranging from
00000 through 99999 to define a horizontal tab of
0.000 inch through 99.999 inches. VGL
automatically understands the decimal between the
second and third digits.
Defines the horizontal tab in thousandth inches.
Enter a five-digit horizontal value ranging from
00000 through 99999 to define a horizontal tab of
0.000 inch through 99.999 inches. VGL
automatically understands the decimal between the
second and third digits.
The data to print at the new print position is input
following the Horizontal Tab command.
following the Horizontal Tab command.
(cc)-
Graphics Mode CR used as a sequence terminator.
Enter the SFCC for your VGL configuration
immediately followed by - to end the command
sequence.
Enter the SFCC for your VGL configuration
immediately followed by - to end the command
sequence.
NOTE: The (cc)- sequence terminator is used only when ^T is a Standard
Graphics command.
Comments
The T command may be input as part of the data in one of the
alphanumeric commands and also may be used in standard
graphics mode.
alphanumeric commands and also may be used in standard
graphics mode.
A 2-inch tab specifies a position 2 inches from the left margin; a
6-inch tab specifies a position 6 inches from the left margin, etc.
Since the tab specifies a print position relative to the left print
margin, you can use tabs to specify a print position to the left or
right of the current position (unlike a typewriter, which can only
tab to the right of the current position). For example, if the current
print position is 4 inches from the left margin and a 1-inch tab is
specified, the next print position is 1 inch from the left margin.
This left/right capability is useful for positioning data within boxes
of a form or similar applications.
6-inch tab specifies a position 6 inches from the left margin, etc.
Since the tab specifies a print position relative to the left print
margin, you can use tabs to specify a print position to the left or
right of the current position (unlike a typewriter, which can only
tab to the right of the current position). For example, if the current
print position is 4 inches from the left margin and a 1-inch tab is
specified, the next print position is 1 inch from the left margin.
This left/right capability is useful for positioning data within boxes
of a form or similar applications.