Printronix l7032 참조 매뉴얼
Direct Printer Commands
53
Direct Printer Commands
Purpose
Sends control characters for special purposes directly to the Line
Printer Plus emulation.
Printer Plus emulation.
Mode
Graphics with a Standard Graphic Command selected
Format
NOTE: The commands in Table 6 are not supported on L7032 printers.
NOTE: Do not use the ^# direct printer command to send hex 03 to the
printer at the start of a line. This is to avoid confusion with the
Compressed Print command described on page 47.
Compressed Print command described on page 47.
Comments
A detailed understanding of Line Printer Plus function and
response to the control characters is recommended. Refer to the
Line Printer Plus Programmer’s Reference Manual for information
regarding the hex codes for various printer commands.
response to the control characters is recommended. Refer to the
Line Printer Plus Programmer’s Reference Manual for information
regarding the hex codes for various printer commands.
The Graphics Mode must be entered before sending the direct
printer commands. However, do not use these commands within
an extended graphics command sequence.
printer commands. However, do not use these commands within
an extended graphics command sequence.
Example
The following example command sequence sends hex 05 to the
printer, initiating the printer plot command to plot the data.
printer, initiating the printer plot command to plot the data.
^PY^-
^% data ^-
Table 6. Direct Printer Commands
Direct Command
Hex Code Sent to the Printer
^ !
01
^ ”
02
^ #
03 (see note below)
^ $
04
^ %
05
^ &
06
^ ’
07
^ (
08
^ .
0E
^ /
0F