Printronix l7032 참조 매뉴얼
Form Length
89
Form Length
Purpose
Defines the length of the form in total number of lines.
Mode
Graphics with a Standard Graphics Command selected
Format
(cc) L
length (cc)-
or
(cc) H
(cc) H
length (cc)-
(cc)
Represents the Special Function Control Code
(SFCC). Enter the specific SFCC for your VGL
configuration.
(SFCC). Enter the specific SFCC for your VGL
configuration.
L or H
The Form Length command. If your VGL is
configured with the PI line enabled, enter L. If your
VGL is configured with the PI line disabled, enter H.
configured with the PI line enabled, enter L. If your
VGL is configured with the PI line disabled, enter H.
length
Represents the form length in total number of lines.
Enter a two-digit number of total lines on the form
ranging from 01 through 99. For example, enter 05
for a 5-line form length, 21 for a 21-line form length.
Enter a two-digit number of total lines on the form
ranging from 01 through 99. For example, enter 05
for a 5-line form length, 21 for a 21-line form length.
(cc)-
Graphics Mode CR. Enter the SFCC for your VGL
configuration immediately followed by - to end the
command sequence.
configuration immediately followed by - to end the
command sequence.
Comments
The L command is available any time VGL is in the Graphics
Mode. The physical length of the paper for the form is a product
of the total lines per form and the current lines per inch (lpi)
setting for the printer. For example, a typical 66-line form at 6 lpi
is 11 inches long. A 48-line form at 6 lpi is 8 inches long; the
same 48-line form at 8 lpi is 6 inches long.
Mode. The physical length of the paper for the form is a product
of the total lines per form and the current lines per inch (lpi)
setting for the printer. For example, a typical 66-line form at 6 lpi
is 11 inches long. A 48-line form at 6 lpi is 8 inches long; the
same 48-line form at 8 lpi is 6 inches long.
Form feeds following this command advance the form from the
current print position to the top of the next form.
current print position to the top of the next form.
With the Host Form Length configuration option enabled, the form
length defined by this command sets the physical page length on
the printer.
length defined by this command sets the physical page length on
the printer.