Elonex n5008 사용자 가이드
ONE User Manual
5
Inputs & Outputs
The ONE has various ports and sockets that let you do various things with the one. The
following explains what all those bits and pieces do.
following explains what all those bits and pieces do.
Left Side Panel (see picture on opposite page)
The Broadband Port (RJ45) at the top is for plugging in a hard wire cable to connect to the
internet or a local network. When removing the cable press the little tab and remove rather
than just pulling as this may damage the port or cable.
than just pulling as this may damage the port or cable.
The ONE has two USB ports for plugging in a range of USB devices. When purchasing any
devices please check the requirements to make sure they will work with your ONE. When
putting your device into the USB just make sure it is the right way round and slot it in.
Right Hand Panel
At the top is the silver power
button.
Below this is the power input.
This is where you should plug in
the power adapter (15V, 2A).
For advice on how to best
charge the battery please read
section 2.
In the middle are the audio
jacks. The green one is Audio
Out (where you can plug
headphones
or
external
speakers into) and the pink one
is Audio In (where you can plug in a sound recorder like a microphone). Both these ports take
a 3.5mm jack plug.
Below this are two LEDs. The top one is the battery charge status. When the power adapter
is attached and the battery is fully charged the light will glow green. If it is still charging up,
the light will glow red. The bottom LED of the two is the power indication light. If your unit is
on the light will glow green.
When playing music you can use the Volume Rocker at the bottom of the panel to increase or
the light will glow red. The bottom LED of the two is the power indication light. If your unit is
on the light will glow green.
When playing music you can use the Volume Rocker at the bottom of the panel to increase or
decrease the volume.