Toshiba M200 사용자 설명서
61
Getting Started
Adding memory
5.375 x 8.375 ver 2.3
Do not try to remove a memory module with the computer
turned on. You can damage the computer and the device.
turned on. You can damage the computer and the device.
Do not remove the memory module while the computer is in
Standby or Hibernation mode. The computer could hang up
the next time you turn it on and data in memory will be lost. In
either of the above cases, the Standby configuration will not be
saved.
Standby or Hibernation mode. The computer could hang up
the next time you turn it on and data in memory will be lost. In
either of the above cases, the Standby configuration will not be
saved.
The following message appears when you turn on the power:
Warning: Resume Failure
Press Any Key To Continue
Press Any Key To Continue
If the computer hangs up when you turn it on, perform the
following: Press the power button and hold it down for at least
ten seconds, then turn the power on again.
following: Press the power button and hold it down for at least
ten seconds, then turn the power on again.
2
Pull the clips away from the memory module.
The memory module pops up slightly.
3
Gently lift the memory module to a 45 degree angle and
slide it out of the slot.
slide it out of the slot.
Removing the memory module
4
Replace the memory module slot cover and tighten the
screw.
screw.