Contax nx 지침 매뉴얼
89
Set the position dial to “CF”.
The display panel is as shown at left
(custom function setting mode).
(custom function setting mode).
Turn the R dial to select
“Function number”.
“Function number”.
Turn the F dial to select “Detail
number”.
Set the position dial to a position
other than “CF”.
other than “CF”.
The custom function is set.
Return the dial to “
Return the dial to “
” (white) or “
”
(green) and take the photograph.
The display panel returns to the normal
display.
The display panel returns to the normal
display.
• To initialize all set functions, display
“CLE” as previously described in 2,
and set to a position other than “CF”.
and set to a position other than “CF”.
88
2. Setting custom functions
Detail number
Function number
Detail number
Detail
Display panel
Function num-
ber
ber
Custom function setting mode
Standard set-
ting (0)
Changed set-
ting (1)
Changed set-
ting (2)
Changed set-
ting (3)
Detail number
Function number
Superimpose
when focused
when focused
On
Off
Rewind auto return
Auto return on
Auto return off
Leave film tip
when rewinding
when rewinding
Film tip not left
Film tip left
Selection of aper-
ture stop-down
button operation
ture stop-down
button operation
Aperture
stopped down
while pressed
Aperture switches
between stopped
down and open
each time button
is pressed
Focus button
function in “MF”
mode
function in “MF”
mode
SAF
CAF
Red-eye reduc-
tion with internal
flash
tion with internal
flash
Off
On
Exposure com-
pensation setting
(with Av, P)
pensation setting
(with Av, P)
F dial
F dial and
R dial
Exposure value
display when zoom
lens is fitted (*)
display when zoom
lens is fitted (*)
Align aperture
ring
Link to zooming
Continued exposure
compensation
compensation
Until power
supply OFF
Until setting
cancelled
Exposure com-
pensation setting
pensation setting
F dial
Set with F dial
while pressing
while pressing
LIGHT button
CLE: Resetting cus-
tom functions
The custom functions (
~
) are always set to the standard settings.
• Note that if the exposure mode selector lever is set to any posi-
tion other than “CF” at this time, all the custom functions are
reset to the standard settings (i.e. to “0”).
reset to the standard settings (i.e. to “0”).
* When using lenses for which the open aperture value (brightness) with zooming varies
(eg. Vario Sonnar 28-80mm F3.5-5.6), the actual aperture is controlled by the camera so
that it assumes the value set with the aperture ring, rather than being controlled by zoom-
ing. Set Custom Function
that it assumes the value set with the aperture ring, rather than being controlled by zoom-
ing. Set Custom Function
to (1) to vary the aperture with zooming.
11-1BC(E)_P086-89 11/15/01 7:29 PM Page 88