Netgear GSM712 참조 가이드

3)  Setup the Port VLAN IDs as follows. 

 
Note: Port 01 PVID is set to 2. This must be done in the port specific page since there is no VLAN with ID 2 
 

 

 
The specific ports above have the following Port VLAN ID settings (The Port VLAN ID settings for each port are configured in the VLAN Ports page): 

 
Port 01: 2    Port 05: 5 

Port 09: 10 

 

Port 02: 1    Port 06: 2 

Port 10: 10 

 

Port 03: 1    Port 07: 10 

Port 11: 1 

Port 04: 1    Port 08: 10 

Port 12: 1 

 
 
The following scenarios will produce results as described below: 

 
1)  If an untagged packet enters Port 4, the switch will tag it with a VLAN tag value of 1. Since Port 4 does not have membership with VLAN 

ID 1 (default), the packet will be dropped. 

 
2)  If a tagged packet with a VLAN tag value 1 enters Port 4, the packet will have access to Ports 2, 3, 6, 11 and 12. If the packet leaves Port 

5 and/or 1, it will be stripped of its tag becoming an untagged packet as it leaves the switch.  

  

 

 
3)  If an untagged packet enters Port 1, the switch will tag it with a VLAN tag value of 2. It will then be dropped since Port 1 has no 

membership with VLAN ID 2.  

 
4)  If a tagged packet with a VLAN tag value 10 enters Port 9, it will have access to Ports: 7, 8, 10, 11, and 12. If the packets leave Ports 7, 8 

or 10, they will be tagged with a VLAN ID value of 10. If the packet leaves Ports 11 or 12, it will leave as an untagged packet. 

 

5)  If a tagged packet with a VLAN tag value 1 enters Port 9, it will be dropped since Port 9 does not have membership with VLAN ID 1.