Netgear GSM712 참조 가이드
Page 62 of 105
Status > Port Settings
This page displays the port settings. To configure the ports, go to the ‘Port Configuration’ under the ‘Set-up’ sub menu.
o Port Number:
The port number on the switch
o Port Name:
The name of the port. This is a user-defined label.
o Link Status:
A green triangle pointing up indicates a valid link, while a red triangle pointing down indicates no link.
o On/Off:
Indicates if the port is enabled or disabled by the Administrator.
o State:
This refers to the Spanning Tree state of the port. Ports will be Blocking (Blk), Listening (Lis), Learning (Lrn),
Forwarding (Fwd) or Disabled (Dis).
Forwarding (Fwd) or Disabled (Dis).
o Speed:
Indicates the speed and duplex for the port. The possible entries are Auto-negotiation (Auto); 10 Mbps half duplex
(10M Half); 10 Mbps full duplex (10M Full); 100 Mbps half duplex (100M Half); 100 Mbps full duplex (100M Full);
or 1G full duplex (1000M Full).
(10M Half); 10 Mbps full duplex (10M Full); 100 Mbps half duplex (100M Half); 100 Mbps full duplex (100M Full);
or 1G full duplex (1000M Full).
o Flow Control:
Indicates whether Flow Control support is set for automatic (Auto) or off (Disabled)
o Trunk ID
Indicates which, if any, trunk that the port belongs to.
Figure 7-6: Port Configuration: Port Settings
Blk =Blocking.
The port is either no link or only receiving PDU packets to monitor the Spanning Tree.
Fwd =Forwarding.
The port is sending and receiving all traffic.
Lrn =Learning.
The port is in learning stage of Spanning Tree Algorithm.
Lis =Listening.
The port is in listening stage.
Dis =Disabled.
The port is disabled by admin.