Netgear GSM7212 사용자 설명서

Switching Commands

8-87

no spanning-tree mst <mstid> {cost | port-priority}

Interface Config

This command adds a multiple spanning tree instance to the switch. The instance <mstid> is a 
number within a range of 1 to 4094, that corresponds to the new instance ID to be added. The 
maximum number of multiple instances supported by the 7200 Series L2 Switch is 4. 

spanning-tree mst instance <mstid>

Global Config

This command removes a multiple spanning tree instance from the switch and reallocates all 
VLANs allocated to the deleted instance to the common and internal spanning tree. The instance 
<mstid> is a number that corresponds to the desired existing multiple spanning tree instance to be 
removed. 

no spanning-tree mst instance <mstid>

Global Config

This command sets the bridge priority for a specific multiple spanning tree instance. The instance 
<mstid> is a number that corresponds to the desired existing multiple spanning tree instance. The 
priority value is a number within a range of 0 to 61440 in increments of 4096. 

If 0 (defined as the default CIST ID) is passed as the <mstid>, then this command sets the Bridge 
Priority parameter to a new value for the common and internal spanning tree. The bridge priority 
value again is a number within a range of 0 to 61440. The twelve least significant bits will be 
masked according to the 802.1s specification. This will cause the priority to be rounded down to 
the next lower valid priority.

32768

spanning-tree mst priority <mstid> <0-61440>

Global Config