Netgear GSM7212 사용자 설명서
User Manual for the NETGEAR 7200 Series Layer 2 Managed Switch Software
Quick Start up
6-3
December 2004, 202-10010-02
Quick Start up User Account Management
Quick Start up IP Address
To view the network parameters the operator can access the device by the following three
methods.
methods.
•
Simple Network Management Protocol - SNMP
•
Telnet
Table 6-3.
Quick Start up User Account Management
Command
Details
show users
(in Privileged EXEC)
Displays all of the users that are allowed to access the switch
Access Mode - Shows whether the user is able to change
parameters on the switch (Read/Write) or is only able to view
then (Read Only).
As a factory default, admin has Read/Write access and guest
has Read Only access. There can only be one Read/Write user
and up to 5 Read Only users.
parameters on the switch (Read/Write) or is only able to view
then (Read Only).
As a factory default, admin has Read/Write access and guest
has Read Only access. There can only be one Read/Write user
and up to 5 Read Only users.
show loginsession
(in User EXEC)
Displays all of the login session information
users passwd <username>
(in Global Config)
Allows the user to set passwords or change passwords needed
to login
A prompt will appear after the command is entered requesting
the users old password. In the absence of an old password
leave the area blank. The operator must press enter to execute
the command.
The system then prompts the user for a new password then a
prompt to confirm the new password. If the new password and
the confirmed password match a message will be displayed.
User password should not be more than eight characters in
length.
to login
A prompt will appear after the command is entered requesting
the users old password. In the absence of an old password
leave the area blank. The operator must press enter to execute
the command.
The system then prompts the user for a new password then a
prompt to confirm the new password. If the new password and
the confirmed password match a message will be displayed.
User password should not be more than eight characters in
length.
copy system:running-config
nvram:startup-config
(in Privileged EXEC)
This will save passwords and all other changes to the device.
If you do not save config, all configurations will be lost when a
power cycle is performed on the switch or when the switch is
reset
If you do not save config, all configurations will be lost when a
power cycle is performed on the switch or when the switch is
reset
logout
(in User EXEC and Privileged
EXEC)
Logs the user out of the switch