Netgear GSM7212 사용자 설명서
User Manual for the NETGEAR 7200 Series Layer 2 Managed Switch Software
8-12
Switching Commands
December 2004, 202-10010-02
Dynamic VLAN Entries - The number of presently active
VLAN entries on this switch that have been created by GVRP
registration.
VLAN entries on this switch that have been created by GVRP
registration.
VLAN Deletes - The number of VLANs on this switch that have
been created and then deleted since the last reboot.
been created and then deleted since the last reboot.
Time Since Counters Last Cleared The elapsed time, in days, hours, minutes, and sec-
onds, since the statistics for this switch were last cleared.
show logging
This command displays the trap log maintained by the switch.
The trap log contains a maximum of 256 entries that wrap.
Format
show logging
Mode
Privileged EXEC
Number of Traps since last reset The number of traps that have occurred since the last
reset of this device.
Number of Traps since log last displayed The number of traps that have occurred
since the traps were last displayed. Getting the traps by any
method (terminal interface display, Web display, upload file from
switch etc.) will result in this counter being cleared to 0.
method (terminal interface display, Web display, upload file from
switch etc.) will result in this counter being cleared to 0.
Log
The sequence number of this trap.
System Up Time
The relative time since the last reboot of the switch at which this
trap occurred.
trap occurred.
Trap
The relevant information of this trap.
Note:
Trap log information is not retained across a switch reset.
show mac-addr-table
This command displays the forwarding database entries. If the command is entered with no
parameter, the entire table is displayed. This is the same as entering the optional
parameter, the entire table is displayed. This is the same as entering the optional
all
parameter.
Alternatively, the administrator can enter a MAC Address to display the table entry for the
requested MAC address and all entries following the requested MAC address.
requested MAC address and all entries following the requested MAC address.
Format
show mac-addr-table [<macaddr> | all]
Mode
Privileged EXEC