Netgear GSM7212 사용자 설명서
User Manual for the NETGEAR 7200 Series Layer 2 Managed Switch Software
8-18
Switching Commands
December 2004, 202-10010-02
Seconds
The <seconds> parameter must be within the range of 10 to
1,000,000 seconds.
1,000,000 seconds.
Forwarding Database ID Fdbid (Forwarding database ID) indicates which forwarding
database's aging timeout is being configured. All is used to con-
figure all forwarding database's agetime. In an SVL system, the
[fdbid/all] parameter is not used and will be ignored if entered.
figure all forwarding database's agetime. In an SVL system, the
[fdbid/all] parameter is not used and will be ignored if entered.
no bridge aging-time
This command sets the forwarding database address aging timeout to 300 seconds. In an IVL
system, the [fdbid/all] parameter is required. In an SVL system, the [fdbid/all] parameter is not
used and will be ignored if entered.
system, the [fdbid/all] parameter is required. In an SVL system, the [fdbid/all] parameter is not
used and will be ignored if entered.
Format
no bridge aging-time [fdbid | all]
Mode
Global Config
Forwarding Database ID Fdbid (Forwarding database ID) indicates which forwarding
database's aging timeout is being configured. All is used to con-
figure all forwarding database's agetime. In an SVL system, the
[fdbid/all] parameter is not used and will be ignored if entered.
figure all forwarding database's agetime. In an SVL system, the
[fdbid/all] parameter is not used and will be ignored if entered.
mtu
This command sets the maximum transmission unit (MTU) size (in bytes) for physical and port-
channel (LAG) interfaces. For the standard implementation, the range of <mtusize> is a valid
integer between 1522-9216.
channel (LAG) interfaces. For the standard implementation, the range of <mtusize> is a valid
integer between 1522-9216.
Default
1522
Format
mtu <1522-9216>
Mode
Interface Config
no mtu
This command sets the default maximum transmission unit (MTU) size (in bytes) for the interface.
Format
no mtu
Mode
Interface Config