Netgear GSM7212 사용자 설명서
User Manual for the NETGEAR 7200 Series Layer 2 Managed Switch Software
Switching Commands
8-45
December 2004, 202-10010-02
Default
60 centiseconds (0.6 seconds)
Format
set garp timer leave <20-600>
Mode
Interface Config
no set garp timer leave
This command sets the GVRP leave time per port to 60 centiseconds (0.6 seconds).
Note: This command has an effect only when GVRP is enabled.
Format
no set garp timer leave
Mode
Interface Config
set garp timer leave all
This command sets the GVRP leave time for all ports. Leave time is the time to wait after
receiving an unregister request for a VLAN or a multicast group before deleting the VLAN entry.
This can be considered a buffer time for another station to assert registration for the same attribute
in order to maintain uninterrupted service.time is 20 to 600 (centiseconds).
receiving an unregister request for a VLAN or a multicast group before deleting the VLAN entry.
This can be considered a buffer time for another station to assert registration for the same attribute
in order to maintain uninterrupted service.time is 20 to 600 (centiseconds).
Note:
This command has an effect only when GVRP is enabled.
Default
60 centiseconds (0.6 seconds)
Format
set garp timer leave all <20-600>
Mode
Global Config
no set garp timer leave all
This command sets the GVRP leave time for all ports to the default 60 centiseconds (0.6 seconds).
Note:
This command has an effect only when GVRP is enabled.
Format
no set garp timer leave all
Mode
Global Config