Netgear GSM7212 작동 가이드

 

connector. 

2.  After the switch has been configured for management (Step 7), use one of the management interfaces 

(web browser or console interface) to configure the port with the SFP module installed to the SFP 
option. 

To install additional Gigabit Ethernet module, repeat this procedure  

 

Figure 3-3.  Installing a Gigabit Ethernet fiber Module into an GSM7212 

 

 

 

 

To learn the IP address, you must first access the Command Line management via the console interface.  
 

After you power-up the switch for the first time, you can connect to it using a VT100/ANSI terminal or a PC, 
Apple Macintosh, or UNIX workstation that is directly connected to the switch’s console port. 

To connect a console to the switch: 

1.     Connect a VT100/ANSI terminal or a PC, Apple Macintosh, or UNIX workstation to the switch’s 

console port, labeled Console, using the null-modem cable supplied with the switch. The supplied null-
modem cable has 9-pin connectors on each end.  

2.     If you attached a PC, Apple Macintosh, or UNIX workstation, start a terminal-emulation program.  

Microsoft Windows users can use HyperTerminal, which comes with the Windows operating 
systems.  

Macintosh users can use ZTerm.  

UNIX users can use a terminal emulator such as TIP. 

3.     Configure the terminal-emulation program to use the following settings: 

Baud rate: 9,600 bps 

Data bits: 8 

Parity: none 

Stop bit: 1