Netgear GSM7224 사용자 설명서

Switching Commands

8-59

This command displays port information.

show port {<slot/port> | all}

The physical slot and physical port.

If not blank, this field indicates that this port is a special type of 
port. The possible values are: 

Mon - this port is a monitoring port. Look at the Port Monitoring 
screens to find out more information. 

Lag - this port is a member of a port-channel (LAG). 

Probe - this port is a probe port.

Selects the Port control administration state. The port must be 
enabled in order for it to be allowed into the network. - May be 
enabled or disabled. The factory default is enabled. 

Selects the desired port speed and duplex mode. If auto-negotia-
tion support is selected, then the duplex mode and speed will be 
set from the auto-negotiation process. Note that the port's maxi-
mum capability (full duplex -100M) will be advertised. Other-
wise, this object will determine the port's duplex mode and 
transmission rate. The factory default is Auto. 

Indicates the port speed and duplex mode. 

Indicates whether the Link is up or down. 

This object determines whether or not to send a trap when link 
status changes. The factory default is enabled. 

Displays whether LACP is enabled or disabled on this port.

This command displays the Protocol-Based VLAN information for either the entire system, or for 
the indicated Group.