Netgear GSM7224 사용자 설명서

Switching Commands

8-101

This command is used to configure the shared secret between the RADIUS client and the RADIUS 
accounting / authentication server. Depending on whether the 'auth' or 'acct' token is used, the 
shared secret will be configured for the RADIUS authentication or RADIUS accounting server. 
The IP address provided must match a previously configured server. When this command is 
executed, the secret will be prompted. The secret must be an alphanumeric value not exceeding 20 
characters.

radius server key {auth | acct} <ipaddr>

Global Config

This command enables the message authenticator attribute for a specifiedserver.

This command is used to configure the primary RADIUS authentication server for this RADIUS 
client. The primary server is the one that is used by default for handling RADIUS requests. The 
remaining configured servers are only used if the primary server cannot be reached. A maximum 
of three servers can be configured on each client. Only one of these servers can be configured as 
the primary. If a primary server is already configured prior to this command being executed, the 
server specified by the IP address specified used in this command will become the new primary 
server. The IP address must match that of a previously configured RADIUS authentication server.

radius server primary <ipaddr>

Global Config

This command sets the maximum number of times a request packet is re-transmitted when no 
response is received from the RADIUS server. The retries value is an integer in the range of 1 to 
15.

10