Netgear GSM7224 사용자 설명서

7-4

Mode-based CLI

The CLI is divided into various modes. The Commands in one mode are not available until the 
operator switches to that particular mode, with the exception of the User Exec mode commands. 
The User Exec mode commands may also be executed in the Privileged Exec mode.

The commands available to the operator at any point in time depend upon the mode. Entering a 
question mark (?) at the CLI prompt, displays a list of the available commands and descriptions of 
the commands.

The CLI provides the following modes:

When the operator logs into the CLI, the User Exec mode is the 
initial mode. The User Exec mode contains a limited set of com-
mands. The command prompt shown at this level is:

To have access to the full suite of commands, the operator must 
enter the Privileged Exec mode. The Privileged Exec mode 
requires password authentication. From Privileged Exec mode, 
the operator can issue any Exec command or enter the Global 
Configuration mode. The command prompt shown at this level is:

This mode permits the operator to make modifications to the run-
ning configuration. General setup commands are grouped in this 
mode. From the Global Configuration mode, the operator can 
enter the System Configuration mode, the Physical Port config, 
the Interface Configuration mode, or the Protocol Specific modes 
specified below. The command prompt at this level is:

From the Global Config mode, the operator may enter the following config modes:

This mode groups all the commands pertaining to VLANs. The 
command prompt shown at this level is:

Many features are enabled for a particular interface. The Interface 
commands enable or modify the operation of an interface.

In this mode, a physical port is set up for a specific logical con-
nection operation. The Interface Config mode provides access to