Netgear GSM7224 사용자 설명서

Switching Commands

8-27

May be enabled or disabled. The factory default is disabled. Indi-
cates whether OSPF traps will be sent. 

May be enabled or disabled. The factory default is disabled. Indi-
cates whether PIM traps will be sent. 

This command adds (and names) a new SNMP community. A community name is a name 
associated with the switch and with a set of SNMP managers that manage it with a specified 
privileged level. The length of name can be up to 16 case-sensitive characters.

Community names in the SNMP community table must be unique. If you make multiple 

entries using the same community name, the first entry is kept and processed and all duplicate 
entries are ignored. 

Two default community names: Public and Private. You can 
replace these default community names with unique identifiers 
for each community. The default values for the remaining four 
community names are blank.

This command removes this community name from the table. The name is the community name to 
be deleted.

This command sets a client IP address for an SNMP community. The address is the associated 
community SNMP packet sending address and is used along with the client IP mask value to 
denote a range of IP addresses from which SNMP clients may use that community to access the 
device. A value of 0.0.0.0 allows access from any IP address. Otherwise, this value is ANDed with 
the mask to determine the range of allowed client IP addresses. The name is the applicable 
community name.