Netgear GSM7324 설치 가이드
Page 10 of 24
• After determining this information, the switch automatically configures the RJ-45 port to enable
communications with the attached device, without requiring user intervention. This Auto Uplink
technology eliminates the need for setting uplink connections or being concerned about whether
to use crossover or straight-through cables when attaching devices.
technology eliminates the need for setting uplink connections or being concerned about whether
to use crossover or straight-through cables when attaching devices.
Figure 2-3. Warning! Do Not Create Redundant Paths between Network Devices
SFP module bay
The last four ports (21,22,23,24) on the GSM7324 can be used for either STP (RJ45) or SFP (fiber) type
cable. However, both port types cannot be used at the same time. The switch will detect the port in use
automatically simply by the first connected interface. If both connectors are plugged in at the same, the
result is undetermined.
The SFP bay accommodates a standard SFP module which has an SC connector that is compatible with
the IEEE 802.3z 1000BASE-SX standard.
cable. However, both port types cannot be used at the same time. The switch will detect the port in use
automatically simply by the first connected interface. If both connectors are plugged in at the same, the
result is undetermined.
The SFP bay accommodates a standard SFP module which has an SC connector that is compatible with
the IEEE 802.3z 1000BASE-SX standard.