Netgear gsm7312 사용자 설명서

Switching Commands

7-43

This command removes the port mirroring designation from both the probe port and the mirrored 
port and removes the probe port from all VLANs. The port must be manually re-added to any 
desired VLANs.

 

This command configures the Port Mirroring mode. The possible values are enable and disable. 
The default value is disable. The probe and mirrored ports must be configured before port 
mirroring can be enabled. If enabled, the probe port will mirror all traffic received and transmitted 
on the physical mirrored port. It is not necessary to disable port mirroring before modifying the 
probe and mirrored ports.

disable

config mirroring mode <enable|disable> 

This command displays the Static MAC Filtering information for all Static MAC Filters. If <all> is 
selected, all the Static MAC Filters in the system are displayed. If a macaddr is entered, a vlan 
must also be entered and the Static MAC Filter information will be displayed only for that MAC 
address and VLAN.    

The MAC Address of the static MAC filter entry.

The VLAN ID of the static MAC filter entry.

Indicates the source port filter set's slot and port(s).

Indicates the destination port filter set's slot and port(s).

This command adds a static MAC filter entry for the MAC address <macaddr> on the VLAN 
<vlan>. The <macaddr> parameter must be specified as a 6-byte hexadecimal number in the 
format of b1:b2:b3:b4:b5:b6. 

The restricted MAC Addresses are: 00:00:00:00:00:00, 01:80:C2:00:00:00 to 01:80:C2:00:00:0F, 
01:80:C2:00:00:20 to 01:80:C2:00:00:21, and FF:FF:FF:FF:FF:FF.