Netgear gsm7312 사용자 설명서

5-2

Command Line Interface Syntax

The text in bold, non-italic font must be typed exactly as shown.

Parameters are order dependent. 

The text in bold italics should be replaced with a name or number. To use spaces as part of a name 
parameter, enclose it in double quotes like this: "System Name with Spaces".

Parameters may be mandatory values, optional values, choices or a combination.

–

<parameter>. The <> angle brackets indicate that a mandatory parameter must be entered 
in place of the brackets and text inside them.

–

[parameter]. The [] square brackets indicate that an optional parameter must be entered in 
place of the brackets and text inside them.

–

choice1|choice2. The | indicates that only one of the parameters should be entered.

This parameter is a valid IP address, made up of four decimal 
bytes ranging from 0 to 255. The default for all IP parameters 
consists of zeros and a one (that is, 0.0.0.1). The interface IP 
address of 0.0.0.0 is invalid. In some cases, the IP address can 
also be entered as a 32-bit number.

The MAC address format is six hexadecimal numbers separated 
by colons, for example, 0:6:29:32:81:40.

Area IDs may be entered in dotted-decimal notation (for example, 
0.0.0.1). An area ID of 0.0.0.0 is reserved for the backbone. Area 
IDs have the same form as IP addresses, but are distinct from IP 
addresses. The IP network number of the subnetted network may 
be used for the area ID.

The value of <router id> must be entered in 4-digit dotted-deci-
mal notation (for example, 0.0.0.1). A router ID of 0.0.0.0 is 
invalid.

This parameter denotes a valid slot number and a valid port num-
ber. For example, 0.1 represents slot number 0 and port number 1.