Netgear gsm7312 사용자 설명서
User Manual for the NETGEAR 7300 Series Layer 3 Managed Switch Software
7-14
Switching Commands
202-10009-01
•
Bit 7 of byte 0 (called the I/G bit) indicates whether the destination address is an individual
address (b'0') or a group address (b'1').
address (b'0') or a group address (b'1').
•
The second character, of the twelve character macAddr, must be 2, 6, A or E.
A locally administered address must have bit 6 On (b'1') and bit 7 Off (b'0').
Format
config network macaddr <macAddr>
config network mactype
This command specifies whether the burnedin MAC address or the locally-administered MAC
address is used.
address is used.
Default
burnedin
Format
config network mactype <local|burnedin>
config network parms
This command sets the IP Address, subnet mask and gateway of the router. The IP Address and the
gateway must be on the same subnet.
gateway must be on the same subnet.
Format
config network parms <ipAddr> <netmask> [gateway]
config network protocol
This command specifies the network configuration protocol to be used. If you modify this value
change is effective immediately. See “save config” on page 74 for more information.
change is effective immediately. See “save config” on page 74 for more information.
Default
none
Format
config network protocol <none|bootp|dhcp>,
where bootp
indicates that the switch periodically sends requests to a Bootstrap Protocol
(BootP) server or a dhcp server until a response is received. none indicates that
the switch should be manually configured with IP information.
(BootP) server or a dhcp server until a response is received. none indicates that
the switch should be manually configured with IP information.
config network webmode
This command enables or disables access to the switch through the Web interface. When access is
enabled, the user can login to the switch from the Web interface. When access is disabled, the user
cannot login to the switch's Web server.
enabled, the user can login to the switch from the Web interface. When access is disabled, the user
cannot login to the switch's Web server.
Disabling the Web interface takes effect immediately. All interfaces are effected.