Netgear FR328S 설치 가이드

a.

Turn off your computer and Cable or DSL Modem.

b.  Disconnect the Ethernet cable (A) from your computer which 

connects to your Cable or DSL Modem.

c.  Connect the Ethernet cable (A) from your Cable or DSL Modem 

to the FR328S firewall’s Internet port.

d.  Connect the Ethernet cable (B) which came with the firewall 

from a Local port on the router to your computer.

e.

Turn on the Cable or DSL Modem and wait about 30 
seconds for the lights to stop blinking. 

Note: To connect to the firewall, your computer needs to be config-
ured to obtain an IP address automatically via DHCP. If you need
instructions on how to do this, please refer to the Reference
Manual on the CD which came with your firewall.

Cable or DSL modem

Model FR328S ProSafe Firewall

Cable or DSL 
modem

Model FR328S ProSafe Firewall

Cable or DSL 
modem

a.

Turn on the firewall and wait for the test light to stop blinking. 

b.

Now, turn on your computer and use a browser like Internet 
Explorer or Netscape to connect to http://192.168.0.1

Note: If you usually run software to log in to your Internet 
connection, do not run that software.

c.

For security reasons, the firewall has its own user name and pass
word. When prompted, enter 

for the firewall User Name 

and 

for the firewall Password, both in lower case letters.

Note: The user name and password are not the same as 
any user name and password you may use to log in to 
your Internet connection. 

a.

You are now connected to the firewall. Click the 

button in 

the Setup Wizard. 

b. Click 

to follow the steps in the Setup Wizard to input the 

configuration parameters from your ISP to connect to the Internet.

Note: If you were unable to connect, please refer to the 
Troubleshooting Chapter in the Reference Manual on the 
CD which came with the firewall.

ProSafe Firewall w/Dial Back-up Port FR328S