Netgear FVS338 설치 가이드

)NSTALLATION

Follow these instructions to set up your firewall. You can also consult the Planning 
Guide and tutorials on the Resource CD or the NETGEAR knowledge base at 
http://kbserver.netgear.com.

•

For Cable Modem Service: When you perform the firewall setup steps be sure to use 
the computer you used when you first set up your cable Internet connection.

•

For DSL Service: You may need information such as the DSL login name (usually an 
e-mail address) and password in order to complete the firewall setup.

a.

Turn off your computer.

b.

Turn off and unplug the broadband modem.

c.

Locate the Ethernet cable (Cable 1 in the diagram) that connects your modem 
and computer.

d.

Disconnect the cable at the computer end only, point A in the diagram.

0RGHP

,QWHUQHW

&RPSXWHU

e.

Securely insert the Ethernet cable from your modem (Cable 1 in the diagram) 
into the Internet port of the FVS338 as shown in point B of the diagram.

f.

Securely insert the blue cable that came with your 

firewall (the Blue NETGEAR 

Cable in the diagram below) into a LOCAL port on the router such as LOCAL 
port 8 (point C in the diagram), and the other end into the Ethernet port of your 
computer (point D in the diagram).

Your network cables are connected and you are ready to restart your network.

Warning: Failure to restart your network in the correct sequence could prevent you 
from connecting to the Internet.

a.

First, plug in the power cord, turn on the broadband modem, and wait two 
minutes.

b.

Now, plug in the power cord, turn on your FVS338, and wait one minute. 

c.

Last, turn on your computer. 

Note: For DSL customers, if ISP provided software logs you in to the Internet, do 
not run that software. You may need to go to the Internet Explorer Tools menu, 
Internet Options, Connections tab page where you can select “Never dial a con-
nection.”

0RGHP

,QWHUQHW

931)LUHZDOO

,QWHUQHW

0RGHP

931)LUHZDOO

&RPSXWHU

d.

Check the FVS338 status lights to verify the following:

•

Power: The power light should turn solid green. If it does not turn solid 
green, see the Troubleshooting Tips in this guide.

•

Test: The test light blinks when the router is first turned on then goes off. If 
after two minutes it is still on, see the Troubleshooting Tips in this guide.

•

Internet: The Internet port light should be lit. If not, make sure the Ethernet 
cable is securely attached to the firewall Internet port and the modem, and 
the modem is powered on.

•

LOCAL: A LOCAL light should be lit. Green indicates your computer is 
communicating at 100 Mbps; amber indicates 10 Mbps. If a LOCAL light is 
not lit, check that the Ethernet cable from the computer to the router is 
securely attached at both ends, and that the computer is turned on.

Before you begin, be sure you have the configuration parameters from your ISP 
handy.

a.

Use a browser like Internet Explorer or Netscape to connect to 

http://192.168.1.1

Note: To connect to the firewall, your computer needs to be configured to obtain 
an IP address automatically via DHCP. If you need instructions on how to do this, 
please refer to the Resource CD that came with your firewall. 

b.

For security reasons, the firewall has its own user name and password. When 
prompted, enter admin

 for the firewall User Name and password for the firewall 

Password.