Netgear RM356 사용자 설명서
Remote Node Configuration
5-1
Chapter 5
Remote Node Configuration
This chapter discusses the protocol-independent parameters used to configure a remote node. The
protocol-dependent (TCP/IP) configuration is covered in a later chapter.
protocol-dependent (TCP/IP) configuration is covered in a later chapter.
A remote node represents both a remote gateway and the network behind it across a wide-area
network (WAN) connection. A remote node is required for placing calls to a remote network or
answering calls from a remote network. One common type of remote node is an Internet service
provider (ISP). When you use Menu 4 to configure your router for Internet access, the router
automatically adds a remote node for you, using default values typical of an ISP.
network (WAN) connection. A remote node is required for placing calls to a remote network or
answering calls from a remote network. One common type of remote node is an Internet service
provider (ISP). When you use Menu 4 to configure your router for Internet access, the router
automatically adds a remote node for you, using default values typical of an ISP.
When a remote node is configured properly, traffic to the remote LAN triggers the router to make
a call automatically (Dial On Demand). Similarly, calls from the remote LAN are answered
automatically and security is checked.
a call automatically (Dial On Demand). Similarly, calls from the remote LAN are answered
automatically and security is checked.
To create a remote node:
1.
Enter 11 from the Main Menu to display Menu 11 - Remote Node Setup.
2.
Enter a remote node number (1 to 4) to edit the remote node and to display Submenu
11.1 - Remote Node Profile.
11.1 - Remote Node Profile.
3.
Press [Enter] at the Press ENTER to Confirm... prompt to confirm your selections.
Press [Esc] at any time to cancel your selections.
lists and describes the fields in the Remote Node Profile menu and explains how to enter
the information in each field.
Note:
If you access only one remote node (not an ISP), create that remote node using
Menu 4 and then edit it with Menu 11. Creating the remote node using Menu 4 and
editing it with Menu 11 makes the remote node the default static route.
editing it with Menu 11 makes the remote node the default static route.