Netgear RT338 참조 가이드
Configuring Windows TCP/IP
B-1
Appendix B
Configuring Windows TCP/IP
Before using FirstGear, you must first verify that a network adapter card is installed in your PC
and that the TCP/IP component is installed and associated with your network adapter.
and that the TCP/IP component is installed and associated with your network adapter.
If you are using a PC with Windows 3.1, you must have a TCP/IP application package such as
NetManage Chameleon. If you are using Windows 95, Windows 98, or Windows NT, TCP/IP is
included in the operating system.
NetManage Chameleon. If you are using Windows 95, Windows 98, or Windows NT, TCP/IP is
included in the operating system.
The instructions in this appendix provide the minimal basic setup that is most commonly used.
Your network administrator might instruct you to enter either less or more information.
Your network administrator might instruct you to enter either less or more information.
Configuring Windows 95 or Windows 98 for IP Networking
To configure Windows 95 or Windows 98 for IP networking:
1.
On the Windows taskbar, click on Start and choose Settings > Control Panel.
2.
Double-click on Network.
Look at the list of installed components. You must have Client for Microsoft Networks, the
TCP/IP protocol, and/or your Ethernet adapter.
TCP/IP protocol, and/or your Ethernet adapter.
If you need the adapter:
a.
Click on the Add button.
b.
Select Adapter, and then click on Add again.
c.
Select the manufacturer and model of your Ethernet adapter, and click on OK.