Netgear RT338 참조 가이드

2-2

Installing and Connecting the Router

The Model RT338 ISDN Router is intended for use in a network of workstations that are 
interconnected by twisted pair Ethernet or Fast Ethernet cables. 

Each workstation in the network must meet the following requirements:

•

Each workstation must have an installed Ethernet network interface card (NIC).

•

Each workstation must be connected by a hub or switch. If all workstations on the network do 
not run at the same speed (10 Mbps or 100 Mbps), a dual-speed hub or switch must be used.

•

Each workstation with a link operating at 100 Mbps must be connected with Category 5 cable.

The Model RT338 ISDN Router uses the Internet Protocol (IP). The IP configuration of your 
network must satisfy the following requirements:

•

All PCs must have TCP/IP installed and selected as the networking protocol.

•

All PCs and the router must be assigned IP addresses. If your ISP has not assigned registered 
IP addresses, your local network uses private addresses as described below. If you are using 
the default Dynamic Host Configuration Protocol (DHCP) function of the router, these private 
addresses are assigned automatically by the router when the PCs are rebooted.

•

All PCs must have the IP address of the router defined as the default gateway. If you are using 
the default DHCP function of the router, this IP address is assigned automatically by the router 
when the PCs are rebooted.