Netgear RT338 참조 가이드
Reference Guide for the Model RT338 ISDN Router
2-8
Installing and Connecting the Router
Verifying Power
After connecting the power adapter to the router and a power source, complete the following steps
to verify that power is correctly applied to the router:
to verify that power is correctly applied to the router:
1.
Switch the POWER switch to ON.
2.
Verify that the PWR LED is lit.
3.
Verify that the TEST LED begins to blink within a few seconds.
4.
After approximately 30 seconds, verify that:
a.
The TEST LED turns off.
b.
The LNK/ACT LED is lit.
If the LNK/ACT LED is lit, the router has established a link to the Ethernet network.
5.
If the LOCAL port is connected to a 100 Mbps device, verify that the 100 LED is lit.
You are now ready to begin configuration of your network, as described in
.”